Back To Products

Plunge Cut Rider Saw

Plunge Cut Rider Saw – For Raised Pavement Marker Installation

From line irradication to inlay/overlay tape installations & from raised pavement marker installations to single blade sawing (up to 54″ blade) – our rider saw has the power and versatility to handle all your projects. Dynatech has over 28 years experience in the pavement marking industry. You know it’s built powerful enough and tough enough to get the job done right when it’s from Dynatech.

Features:

• 78hp turbo deutz deisel engine
• electric start
• forward/reverse
• hydraulic driven blade shaft
• adjustable depth stop
• quick disconnect blade guard
• heat exchanger for hydraulic oil utilizing air for cooling
• variable rpm with NO horsepower loss
• accommodates blade set-ups for any marker installation
• easily converts to single blade cutting 14″ through 54″
• converts from a down cut to an up cut saw in less than a minute
• arm mounted blade raises and lowers easily(while engine and operator stay level)

Saw easily converts into:

• Floating Head Saw for tape installtion/line removal
• Slot Cutting Saw for recessed/bannana/taper cuts

Plunge Cut Rider Saw Specifications:

Maximum width of cut: 7 “

Maximum depth of cut: adjustable for any marker/tape install

Blade guard capacity: 14″ – 54″

Blade shaft diameter: 2-1/2″

Arbor diameter: 1-3/4″ with dual drive pin

Blade shaft bearings: precision ball

Blade shaft drive: hydraulic motor

Blade mounting: right

Blade raise and lower: hydraulic pump, solenoid valve controlled

Blade coolant: dual multi spray tubes

Blade guard attachment: slip-on/bolt-on

Front wheel dimensions: 10″ x 4″ x 1-1/4″

Rear wheel dimensions: 12″ x 6-1/2″ x 8″

Transmission: variable displacement hydraulic pump and motor

Drive system: direct/hydraulic

Air filter: 4 stage

Fuel capacity: 9 gallons

Electric start: standard

High temperature shut-off: gauge/light

Low oil alert: warning light

Hour meter: standard

Tachometer: standard

Amp meter: warning light

Adjustable depth stop: standard

Blade shaft wrench: standard

Quick disconnect blade flanges: standard

Hydraulic oil capacity: 16 gallons

Plunge Cut Rider Saw Dimensions:

Saw Height: 67-3/4″

Min. Length Pointer Up: 82″

Max. Length Pointer Up: 129-1/4″

Frame Width: 45″

Frame Length: 58″

Saw Width: 64-5/8″

Front Axle Center Length: 39-7/8″

Rear Axle Center Length: 20-3/4″

Wheel Base Length: 47-1/2″

Blade Shaft Max Height: 31-5/8″